One of the biggest little complaints I get from folks in my office is that MicroStation does not have a "Send to Back" tool. I point out that we have a "Bring to Front" and Element Priority, but these concepts are not quite the same.
If I were to attempt writing a "Send to Back" routine, does anyone have any suggestions? I'd prefer VBA because I haven't gotten very far learning MDL/C, and I can write VBA without needing to compile anything. I should probably learn C++, but that's going to take some time, too.
A apologize for the vagueness. I'm looking for directions and ideas before I jump into coding. I'd prefer to pick the sharp minds around here than come to you in three weeks with some code that's just all the way wrong.
Thank you